How To Replace Chevy Hhr Camshaft Position Sensor
How To Replace Chevy Hhr Camshaft Position Sensor. The camshaft position sensor is located on the backside of the engine between the engine and the firewall. To change the crank sensor u would have to pull the starter ,located above starter.
If not removing camshaft position sensor housing, proceed to installation step 6. 1 female connector quantity sold : I went to advanced auto and bought a new one for $67.00 and put it in myself in under 1/2 hour.
Then Shop At 1A Auto For A High Quality Cam Angle Sensor Replacement For Your Chevrolet Hhr At A Great Price.
P0014 camshaft position b over advance,or system performance bank 1.clear the code,this appeared from either logic or rational.camshaft postion usually appear on vehicle that are not in oil maintaince,this sensor has a tendency to get sluge built in it.this also appear when driver run the fuel very low,clear the code if it reappear its a hard code and a replacement or a. My check engine came on and the code says cam sensor malfunction i have replaced the front cam sensor. Below is the procedure for replacing the sensors.
Disconnect The Negative Battery Cable With The Socket Wrench.
Remove camshaft position sensor retaining screws and camshaft position sensor from camshaft position sensor housing. If removing camshaft position sensor housing from the cylinder block (6010), proceed with removal step 5. On some vehicle models, replacing the sensor is just as easy as unplugging the electrical connector, unscrewing the mounting bolt, pulling the sensor out, and installing a new one.
Camshaft Position Sensor Replacement Cost.
Remove the camshaft sensor by removing the screws that are holding it on the distributor, and place it on a clean rag. If this does not work, try turning the collar just behind the keyswitch counter clockwise while trying to remove the key.thanks, dana. The camshaft position sensor is located on the backside of the engine between the engine and the firewall.
If Not Removing Camshaft Position Sensor Housing, Proceed To Installation Step 6.
This sensor uses a reluctor to gauge the position of the crank. Both are shown, just replace whichever one is bad. How to clean camshaft sensors.
Intake Cmp Shown, Exhaust Cmp Similar.
You may want to try pushing fordward harder into the park position while turning the key to the off position. Crankshaft position sensor replacement service how much does a crankshaft position sensor replacement cost? You will need to jack the car up and preferable put the axles on jack stands.
Post a Comment for "How To Replace Chevy Hhr Camshaft Position Sensor"