How To Test Hunter Rain Sensor
How To Test Hunter Rain Sensor. The two leading manufacturers of irrigation products, rain bird and hunter, both make rain sensors and both detect rain using the same method. Locate the rain sensor for your irrigation system.
@dlane, the rain sensor was green before i replaced my old hunter controller. The rain sensor will only interrupt watering in manual all stations and automatic programming. To test the rain sensors, you can try to switch it on manually.
@Dlane, The Rain Sensor Was Green Before I Replaced My Old Hunter Controller.
Connect the blue and white wire to any of the four sensor terminal pairs (sen 1 shown). Make sure the sensor and receiver are installed in such a way that communication is allowed. Check the main controller and ensure that it.
Turn On The Time Clock For The Zone Nearest The Sensor.
The sensor by using the sensor switch on the front panel. They have a series of porous cork discs that when they get wet from rain, they expand and force the sensor to prevent the controller from watering. Activating the zone, then manually activating the sensor.
Manual Single Station Will Override The Sensor Circuit.
Landscape contractor lawn care certified irrigation contractor thru the irrigation association you can contact us at 928.225.2224 or info@aimflagstaff.com flagstaff, az. If the radio signal is obstructed, the controller may not respond to the active sensor. With a rachio (gen 1, 2 or 3) a rain sensor is a “belts and suspenders” approach to catch the situation where there is no precipitation forecast, but it does rain before or during a scheduled run.
Locate The Rain Sensor For Your Irrigation System.
Remove the jumper from the two “sen” terminals. Press and hold the quick response test spindle on the top of the sensor. Within a few seconds the led light on the bottom of the sensor will briefly flash.
Similarly, How Do You Test A Hunter Wireless Rain Sensor?
• look for breaks in the wire leading to the receiver and check all connections. To verify your hunter rain sensor is working properly, you can test the communication with a few simple tasks. You can manually test proper operation of the rain sensor by using the one touch manual start.
Post a Comment for "How To Test Hunter Rain Sensor"