Red Cube Fuel Flow Sensor
Red Cube Fuel Flow Sensor. Two of the wires from the flow sensor connect to inputs of the eis. Fuel flow sender notes the jet supplied with the fuel flow sender may have been installed for your convenience if we know that you need the low range fuel flow sender.
Rotax engine model 912 912 s 914 procedure maximum fuel flow litres / hr 24 33 min flow to be recorded: Minimum fuel flows that must be recorded during the fuel flow check. Every 500 litres or so drain remaining fuel and check/reset fuel qty.
First, The Item That Gave Me A Bit Of A Fit, The “Red Cube” (Fuel Flow Transducer) Was Installed.
When installing fittings into the transducer. Electronics international fuel flow transducer ft60. Fuel flow senders from other manufactures (e.g.
Its Been Used For 150 Hours And Has Worked Flawlessly For That Time.
Ems setup > sensor debug data > c37 p14 (if you've used the default pin) should show activity when fuel is flowing if it's working electrically. The wisdom of the rv community suggested that the best location of the red cube fuel flow transducer is between the fuel servo and the fuel flow divider. Connect the flow sensor's red wire to the instrument's +12v fuel flow power.
The Cube Has 3 Wires, 2 Are For Powering The Sensor And The Other Wire Is The Signal Back To The Fc10.
Red cube fuel sensors and wiring i installed the red cube fuel flow sensors on the firewall and made up new fuel lines running from the fuel pump/filter (supply line) and from the red cube back to the header tanks (return line). Use with boats, trucks, generators. Download spec sheet faa approved instrument faa tso'd and stc'd up to 350 hp engines, engine driven fuel pumps only.
These Are The Red And White Wires.
Rotax engine model 912 912 s 914 procedure maximum fuel flow litres / hr 24 33 min flow to be recorded: Every 500 litres or so drain remaining fuel and check/reset fuel qty. Litres / hr 30.00 33.75 41.25 it is acceptable to conduct this check with.
17 Reviews 19 Answered Questions.
One thing to remember is not to have any 90 degree bends or elbows in the fuel line within 6 of the red cube as it causes turbulence. Please note that a pressure drop may be caused by the sender at high fuel flow rates. The red cubes are quite reliable, for what it's worth.
Post a Comment for "Red Cube Fuel Flow Sensor"