Dd13 Fuel Compensation Pressure Sensor Location
Dd13 Fuel Compensation Pressure Sensor Location. Diesel particulate filter (dpf) inlet pressure sensor sensor measures pressure between the diesel oxidation catalyst (doc) and the diesel particulate filter (dpf) in the aftertreatment assembly located in the exhaust system of the vehicle. Refer to section installation of the fuel compensation pressure sensor.
Egr delta p sensor 12. It is not setting off a code. I took the line off the pressure limiting valve while cranking and there is no fuel
If The Fuel Compensation Pressure Is Less Than 69 Kpa (10 Psi), Replace The Fuel Compensation Pressure Sensor.
16.0 spn 3480 fuel line pressure sensor above or below normal operating range 16.1 spn 3480 fmi 1. Fuel compensation pressure sensor 2. Two things can happen.if the pressure bleeds down to ~60psi and stops, you have high pressure fuel side leak.
Once Pressure Is Achieve, Close The Inlet Shutoff Valve And Monitor The Pressure On The Gauge.
It is not setting off a code. Fuel compensation pressure (gen1 fuel system) dd13 dd15tc dd16 (gen2 fuel system) dd15at 448 to 655 kpa (65 to 95 psi) 551 to 965 kpa (80 to 140 psi) note: The code i have its fuel rail pressure too low, it has a hard time starting and at 1000rpm its cutting, its not idlingling smooth.
Engine Oil Pressure Sensor 10.
Intake air temperature sensor 13. * click image to see larger view. The insulation is rated to 105°c.
Doser Fuel Line Pressure Sensor Circuit Failed High Table 1.
I have a dd13 with a no start issue. I took the line off the pressure limiting valve while cranking and there is no fuel 3.3 installation of the dd13 exhaust flanged manifold.
Spn 4077/Fmi 3 Description This Fault Code Sets When The Motor Control Module (Mcm) Detects That The Hydrocarbon (Hc) Doser Fuel Line Pressure (Flp) Sensor Circuit Is Failed High.
We recognize this nice of dd13 doc inlet. Water coalescer/final filter drain 25. Hc doser fuel supply pressure control valve (km59 gen1 only) 28.
Post a Comment for "Dd13 Fuel Compensation Pressure Sensor Location"