How To Replace Throttle Position Sensor On Dodge Ram 1500
How To Replace Throttle Position Sensor On Dodge Ram 1500. To reset the dodge ram throttle position sensor, you turn on the ignition without your foot on the brake, so the engine doesn't start. Hold the motor up while straying.
Take off neg battery cable. Check out free battery charging and engine diagnostic testing while you are in store. On average, the cost for a dodge ram 1500 throttle position sensor (tps) replacement is $144 with $49 for parts and $95 for labor.
First, Disconnect The Electric Connector From The Sensor.
If the calibration does not help you, you can try cleaning or replacing the sensor. You should see a mark like “on” on the side of the ignition. The following procedure must be performed when replacing this throttle body:
You Will Not Be Starting The Engine, Just Turn The Key To The Next Right Stop.
A bad throttle position sensor can cause other issues on your car if left unattended. Spring (ms.magnumslt) was havin the same problem in her truck. Although the engine kept running, i restarted cruise again, and it worked.
Replace Parts, Then Do The Throttle Position Relearn.
She said that she cleaned her throttle body and replaced the tps and it's fixed. Crank and drive and see if there is a difference. Check out free battery charging and engine diagnostic testing while you are in store.
Duralast Throttle Position Sensor (Tps) Tps343.
How to reset dodge ram throttle position sensor? Hold the motor up while straying. In this video i will explain how a (tps) throttle position sensor works, how.
If The Sensor Is Faulty, It Will Cause Your Car To Shake Heavily.
Prices may vary depending on your location. Disconnect batterys for 20 min. Unplug the throttle position sensor connector.
Post a Comment for "How To Replace Throttle Position Sensor On Dodge Ram 1500"