Hunter Pro C Rain Sensor Not Working
Hunter Pro C Rain Sensor Not Working. Turn the rain sensor switch to the on position. In this tutorial, you learn how the different parts of the rain sensor module are working and how to connect the rain sensor module to your arduino, esp8266 or esp32 microcontroller board.
I know that each zone works. Leaves, debris, and even bugs can fill up the collection cup, causing the sprinklers to shut off. My hunter pro hc rain sensor says, “not active,” is something wrong?
Unfortunately, It Looks Like The Rain Sensor Is Not Allowing The System To Run.
Turn the rain sensor switch to the on position. Is the reading zero or near zero resistance unless the sensor is tripped (red light on)? If wet, loosen the cap of the sensor, or remove so you can get a short circuit reading.
Incompatible Rain Sensor Or The Jumper Was Not Removed When
Expansion disk rain sensors operate via a gauge attached to the sprinkler system. However, in the following instructions it will not matter which wire is connected at a given junction. Choose the type of sensor (most hunter sensors are normally closed).
Has Brown White And 2 Red Wires.
Most modules have location mounts on the firewall inside the engine. If the wipers do not move, refer to your owner's repair manual for the location of the rain sensor module. Rain sensor will not shut off system.
My Hunter Pro Hc Rain Sensor Says, “Not Active,” Is Something Wrong?
Have rain sensor i want to add from old controller. It will be a small plastic box that receives the wires from the sensor. The hunter pro c irrigation controller can be set up to control multiple irrigation stations.
It Has A Weather Sensor That Can Turn Off The Irrigation When Rain Is Detected.
Leaves, debris, and even bugs can fill up the collection cup, causing the sprinklers to shut off. We recently purchased a new home with a hunter pro c controller on the irrigation system. If dry, wet the sensor thoroughly to get an open reading.
Post a Comment for "Hunter Pro C Rain Sensor Not Working"