C1336 Zero Point Calibration Of Deceleration Sensor
C1336 Zero Point Calibration Of Deceleration Sensor. Code c1336 is for deceleration sensor zero point calibration undone. Vsc and traction lights are on.
Turn the ignition switch off. After ecu was replaced, when the shift lever was moved other than to p position within 15 sec. The operation for extinguishing warning light is available in.
Deceleration Sensor Zero Point Calibration Tech Tips:
C1336 is zero point calibration of deceleration sensor undone in the book and can be caused when any of following 1. When the deceleration sensor zero point recorded in ecu is deleted. Turn the ignition switch off.
Hello, As Topic Suggests, I Have 2 Errors When I Plug In My Scanner To The Car C1210 Zero Point Calibration Of Yaw Rate Sensor Undone C1336 Zero Point Calibration Of Deceleration Sensor Undone Anyone Came Across These Before And Know How To Fix Them?
Perform the deceleration sensor zero point calibration. Select “clearing yaw ratio/acceleration sensor zero point (to ecb), and then the screen will prompt a dialog box. To perform zero point calibration, have the steering wheel in the straight ahead position and have the vehicle on a level surface within an inclination of 1%.
| What Is C1336 Code Meaning?
| c1336 toyota code possible causes. * if the slip indicator light does not blink, perform zero point calibration again. After ecu was replaced, when the shift lever was moved other than to p position within 15 sec.
Dtc C1336 / 39 Zero Point Calibration Of Deceleration Sensor Undone Circuit Description Dtc No.
Turn the ignition switch off. To perform zero point calibration, have the steering wheel in the straight ahead position and have the vehicle on a level surface within an inclination of 1%. To perform zero point calibration, have the steering wheel in the straight ahead position and have the vehicle on a level surface within an inclination of 1%.
Vsc And Traction Lights Are On.
Code c1336 is for deceleration sensor zero point calibration undone. Soon after ecu terminal ig1 become on for the first. Shift the shift lever in p position and turn the ignition switch on, repeat connecting and releasing ts and e1 terminals of dlc1 4 times or more for 8 sec.
Post a Comment for "C1336 Zero Point Calibration Of Deceleration Sensor"