97 Buick Lesabre Crankshaft Position Sensor
97 Buick Lesabre Crankshaft Position Sensor. Posted on jul 15, 2014. If any of the above signals goes missing, your 3.8l gm vehicle will crank but not start.
P0344 is an obdii diagnostic code. When the lesabre’s ecm determines that there is an issue with the signal coming from this sensor, it’ll throw the p0335 trouble code. The p0336 fault code on 1997 buick lesabre is a fault in the crankshaft position sensor circuit.
When The Lesabre’s Ecm Determines That There Is An Issue With The Signal Coming From This Sensor, It’ll Throw The P0335 Trouble Code.
Pull the front cover off of it, behind the crankshaft balancer, the sensor is there. Some college and advanced training. Crank shaft sensor.spark.balancer.bolt will not move.
My Buick Lesabre Limited Keeps On Stalling Its A 97 With A 3800 Motor145.000 Miles.
1998 buick lesabre 3.8l sfi ohv 6cyl the dual crankshaft position (ckp) sensor is mounted to the front of the engine, attached to an aluminum bracket mounted to the left side of the engine at the timing chain cover. It probably won't be visible without first removing the power steering reservoir, and possibly other items on that side of the engine. My car failded the smog test because of two problems.
Service Type Crankshaft Position Sensor Replacement:
The p0336 fault code on 1997 buick lesabre is a fault in the crankshaft position sensor circuit. Here is how you can easily test both your crankshaft position sensor and camshaft position sensor. It is a generic code, which means that it has the same meaning for the buick lesabre as it would any other vehicle.
1995 Buick Park Avenue 3.8L Super Charged.
The process to replace the crankshaft position (ckp) sensor on many buick models is rather involved, since you must remove the drive belt and balancer/pulley from the crankshaft. My buick lesabre limited keeps on stalling its a 97 with a 3800 motor145.000 miles. Trying to change crank shaft sensor,because i can get no spark,i can not get the harminic balancer off,bolt will not move,tearing the balancer up.95 buick lasabre.
Location Of Crank Sensor On 1997 Lesabre.
Posted by m jay on jul 06, 2014. 97 lesabre won't start,starter is fine, battery good,replaced crank position sensor, can short the starter out and it will run about 60 seconds. Camshaft position sensor → circuit intermittent.
Post a Comment for "97 Buick Lesabre Crankshaft Position Sensor"