2009 Chevy Malibu Camshaft Position Sensor Location
2009 Chevy Malibu Camshaft Position Sensor Location. No check engine light on. Below, you’ll find some typical issues that cause p0014.
The camshaft position (cmp) sensor is located in the right side of the engine compartment at the rear of the valve cover, near the intake manifold. Three problems related to camshaft position sensor have been reported for the 2010 chevrolet malibu. Where is the camshaft position sensor on a 2013 chevy malibu?
The Exhaust Is On The Front Off The Engine And Intake On The Back.
The camshaft sensor is located on the top of the block directly behind the intake manifold. Where is the camshaft position sensor on a 2013 chevy malibu? At the right rear of the engine under the intake manifold and to the left of the oil filter.
This Includes The Chevy Malibu.
Take the air intake hose off at the filter housing, looking in from the drivers side and at the front of the cover look down towards the throttle body, you'll see a worm style clamp where the plastic housing sits on. On your 2009 chevrolet malibu ltz, the crankshaft position sensor is mounted to the engine block above the starter. This helps optimize the efficiency of your malibu as well as increasing performance.
My Engine Light Is On.
Check if this fits your 2009 chevrolet malibu. Fuel injectors (located on the back of the engine near the intake manifold) mass airflow sensor (maf) camshaft position sensors (cmp) (located at the back of engine) oil pressure sensor (located at the back of the engine) knock sensor (ks) (located on the back side towards the front of the engine under intake manifold) P0014 means that the camshaft position is too far advanced from where it should be in relation to normal operating specs.
My Car Has 128000 Miles.
I am working on a 2009 chevy malibu with a 4 cly echotec. I am working on a 2009 chevy malibu with. It is at the top of the engine, near the front, and the one on the back side of the engine.
The Computer Then Uses This Information To Set Ignition And Fuel Injector Timing.
I have a 2009 chev malibu 2.4 litre showing a poo13 code,itshowed a p0010also until i changed both camshaft position sensers now it is showing just the p0013.i read some chevrolet bulletins it said to put dieletric lube on the connections,stillshow the poo13 code.i pulled the senser out closest to the firewall,it had some brownish sludge on it,i wiped it. Please also check out the statistics and reliability analysis of the 2010 chevrolet malibu based on all problems reported for the 2010 malibu. The engine camshaft position sensor reports the precise location of the camshaft to the powertrain control module (pcm) to determine engine mechanical operation.
Post a Comment for "2009 Chevy Malibu Camshaft Position Sensor Location"