Mercruiser Water Pressure Sensor Fault
Mercruiser Water Pressure Sensor Fault. One of the sensors is not functioning correctly. The water pressure sensors on these engines can cause issues.
The better bet is the map sensor. 881879t26 not in stock (list price 201.25) 888590002 trim sensor verado i6 200, 225, 250, 275, 300 hp mfg part #: Be sure to double check the codes.
Nmea 2000/J1939 Alarm Data Is Limited, Refer To The Mercmonitor Display For Descriptive Fault Text.
Oil pressure, oil level, engine temperature. But you will need to have the engine checked with a computer to verify that the water pressure sensor is the issue. The two that come to mind are low engine oil pressure, and low pressure sea pump.
Low Water Pressure The Bell And Water Pressure Icons Are Displayed.
Water pressure water pressure in the cooling system is low. 888590002 in stock (list price 121.00) 8888 o ring, temp sender. In some cases the small opening where the hose goes into the electronic sensor gets plugged.
You May Be Able To Clear It By Soaking In Something Like Engine Tuner Or Fluid Film, And Then Take A.
Shouldn't give you any further trouble. Stop immediately and check engine oil. Then run the motor, over 2500 rpms in gear.
If All Fluid Levels And Gauges Are Normal You Have A Faulty Sensor.
After running 10 to 15 minutes at a cruising speed of about 3400 rpm, the engine alarm sounds. They were suspect to static discharge. “pwr limit” = percentage of power available (may be limited by engine guardian).
5 Critical ‑ Throttle Control
If you have any kind of hit on water pressure or guardian or overspeed for no reason, do this !!!! Water pump may be faulty. There isn't much you can do till you have the engine checked.
Post a Comment for "Mercruiser Water Pressure Sensor Fault"