Hyundai Accent Crankshaft Position Sensor Problems

Hyundai Accent Crankshaft Position Sensor Problems. That fault is usually caused by an issue coming from your accent’s camshaft position sensor, or the sensor itself. Needed to replace this part on my wife's car.

For Hyundai Accent Crankshaft Position Sensor 20002006 2 from www.ebay.com

Vehicle has a p0016 code which is the only code being thrown. Also please check out the statistics and reliability analysis of hyundai elantra based on all problems reported for the elantra. Its held in place with one or 2 screws (can’t remember) and simply disconnects from.

Source: www.ebay.com

When the accent’s ecm determines that the signal coming from this sensor is out of range, it’ll throw the p0336 trouble code. The car sensors keep going up.

Source: www.ebay.com

Before you conclude that the crankshaft position sensor is bad you may need to run some tests. Vehicle has a p0016 code which is the only code being thrown.

Source: www.walmart.com

Vehicle has a p0016 code which is the only code being thrown. Put a new ignition coil and battery and it started right up.

Source: crankbydesign.blogspot.com

However, just 2 weeks later same exact problem again. Also please check out the statistics and reliability analysis of hyundai elantra based on all problems reported for the elantra.

Source: www.ebay.com

The check engine light doesn't always come on, though, so you could be experiencing any of the above symptoms for some time before you see the warning light. The p0335 dtc is set once the powertrain control module pcm fails to detect proper sensor operation from the crankshaft position sensor.

Source: www.walmart.com

I put new plugs and wires, cam shaft and crank shaft sensors, fuel filter and fuel. Many of the issues mentioned above can be caused by failures in the ignition system or fuel injection system.

Also Please Check Out The Statistics And Reliability Analysis Of Hyundai Elantra Based On All Problems Reported For The Elantra.

The vehicle runs and drives fine with no misfires or idle. I had to replace the crankshaft position sensor after some advice from this site. The vehicle has 146,000 miles.

When Pull Out On To A Street Or Highway And Press The Accelerator Sometimes My Car Will Stall Or Drop Speed.

The car sensors keep going up. Check plugs, wires and coils. When the accents ecm determines that there is an issue with the signal coming from this sensor itll throw the p0335 trouble code.

1 Crankshaft Position Sensor Problem.

The tach began working again, brakes stopped being super touchy, and the car would shift fine again, problem solved. Vehicle has a p0016 code which is the only code being thrown. Hyundai accent 2001 hatchback 146000 miles.

I Bought The Car After It Has Been Sitting For A Year.

Please also check out the statistics and reliability analysis of the 2011 hyundai accent based on all problems reported for the 2011 accent. A diagnostic scan tool will show a code between p0335 and p0338. Put a new ignition coil and battery and it started right up.

Hyundai Accent Owners Have Reported 2 Problems Related To Crankshaft Position Sensor (Under The Electrical System Category).

Also please check out the statistics and reliability analysis of hyundai accent based on all problems reported for the accent. Customer replaced both cam and crank sensors and code still returns. Crankshaft position sensor problems of the 2010 hyundai accent.