Saturn Crankshaft Position Sensor Location
Saturn Crankshaft Position Sensor Location. Due to the mounting locations of this sensor, it is common for heat and oil leaks to cause this sensor to fail. On the 2.4l engine, the crankshaft position sensor is mounted to the engine block behind the alternator, just above the oil filter.
Well no picture to send without showing most all sensor locations it is located just under the right side exhaust manifold, , right side of engine or side closest to the firewall it is #13 in the picture it is held in by one 10mm bolt. The crankshaft sensor is going to use a tone or reluctor ring to determine the position of the crank. You have to lift the car up to get underneath it.
I'll Check Out The Link Once I'm Off Work, Thanks.
On the 3.0l, 3.3l and 3.8l engines, the crankshaft position sensor is mounted on the transaxle housing, above the vehicle speed sensor. The magnetic field of the sensor is altered by a crankshaft mounted reluctor wheel that has seven machined slots, 6 of which are equally spaced 60 degrees apart. You should now have a pretty clear view of the knock sensor (the wires that look like they just go to a bolt, not shown) and the crank position sensor, as shown below.
One Is In The Front And The Other Is In The Back.
If you need further assistance with your crankshaft position sensor, then seek out a professional, such as one from your mechanic, to help you. The ac was not cooling when the vehicle was in idle. The 1998 saturn sl2 will show a code 340 and 341 for a camshaft position sensor because this part is also considered the crankshaft position sensor on the saturn.
The Saturn Outlook Utilizes A Crankshaft Position Sensor In Order To Regulate The Engine Timing.
Crankshaft position sensor on right rear of engine, near top. Unplug, remove the bolt, twist and pull it out while twisting to break the o ring seal The crankshaft sensor is going to use a tone or reluctor ring to determine the position of the crank.
The Crankshaft Sensor On The Other Hand Is A Pain In The A** To Find.
If this ring fails, the vehicle will not be able to get an exact crank position. I would get them to change the crankshaft sensor if you need to do that to get it running and go somewhere else for a second opinion on the alternator. Customer has several questions about his saturn including ignition and tire replacement* the crank sensor was replaced, the shift light indicator in the drive position went out while the headlights were on.
3.0L V6 Engines (From Service Manual Descriptions);
The location of the crankshaft. As the crankshaft rotates, the reluctor wheel teeth interrupt a magnetic field produced by a magnet within the sensor. The crankshaft position sensor is located on the driver side of the engine and in the back by the transmission on the engine.
Post a Comment for "Saturn Crankshaft Position Sensor Location"