2004 Kia Optima 2.7 Crankshaft Position Sensor Location
2004 Kia Optima 2.7 Crankshaft Position Sensor Location. Bret bodas on june 30, 2010. (1) camshaft position sensor, and (1) crankshaft position sensor configuration :
Your computer uses information from the kia optima camshaft position sensor to control the timing of the engine and if it stops working, the engine won't run. If reusing timing belt, place mark on timing belt to indicate direction of belt rotation. Came up with 0335 (crankshaft engine sensor position a)code as primary fault, and 0102 (massairflow, low input) code as secondary.
This Sensor Uses A Reluctor To Gauge The Position Of The Crank.
Good loock read full answer Remove the sensor from the rear of cylinder head. 1 female connector quantity sold :
Use A Screwdriver With A Shaft Measuring 8 Mm (0.3In.) In Diameter Which Can Be Inserted By More Than 60 Mm (2.36 In.) 7.
To remove camshaft position sensor. 2004 kia optima 122,000 mi, engine has 58000 miles on timing belt replaced in 2010. Crankshaft position sensor 2004 kia optima.
How To Replace Crankshaft Position Sensor.
The crank sensor should be located on the left rear of the engine nearest the bell housing. It's real easy now that they're available online. (1) camshaft position sensor, and (1) crankshaft position sensor configuration :
Where Is The Crank Position Sensor At On A Kia Optima.
It is at the lower right of the exhaust manifold. |what is p0335 kia code meaning? Disconnect wire connector from sensor.
I Recommend You Get A Repair Manual If Your Going To Work On Your Own Vehicle.
Posted on dec 21, 2010. This car have a crankshaft and camshaft sensor the crankshaft sensor is loceted in near the pulley crankshaft and the camshaft sensor is located in the camshaft cover behind the radiator. When the optima’s ecm determines that there is an issue with the signal coming from this sensor, it’ll throw the p0335 trouble code.
Post a Comment for "2004 Kia Optima 2.7 Crankshaft Position Sensor Location"