How To Reset Tire Pressure Sensor Chevy Silverado 2011
How To Reset Tire Pressure Sensor Chevy Silverado 2011. Tighten the torx screw to 1.3 n.m (11.5 lb in).tire pressure sensors often use a battery, and a flashing tire pressure light can often be a sign that the battery needs to be replaced.to reset your tire pressure sensors on your 2009 chevy silverado step 1. If your chevy is not equipped with the driver information cluster, press and hold the odometer reset until the “tire learning active” message displays;
Press and hold in the tpms reset button (located under the steering wheel) until the tire pressure light flashes 3 times then release. Press on the valve stem for a few seconds to let air out of the tire until the horn chirps. Www.pinterest.com after the horn chirp has sounded, proceed as in step 4 for the next 3 sensors in the following order:
The First Thing You Will Need To Do Is Go To The Tire You Want To Start With, Which Is The Front Driver's Side Tire.
Resetting the tire pressure sensor on your 2008 chevy silverado can be somewhat complicated, but will only take about 10 to 12 minutes of your time. If you have 2007 2008 2009 2010 2011 colorado, you can reset the tpms by increasing or decreasing the tire pressure without using tools. To reset your tire pressure sensors on your 2009 chevy silverado step 1.
Remove The Torx Screw (1) From The Tire Pressure Sensor (2) And Pull It Straight Off The Tire Pressure Valve Stem (3).Remove The Valve Cap From The Valve Cap Stem.repeat The Process For The Passenger Side Front Tire, Passenger Side Rear Tire, And The Driver Side Rear Tire.
Www.pinterest.com after the horn chirp has sounded, proceed as in step 4 for the next 3 sensors in the following order: Start the vehicle but give it about 20 mins or so to completely reprogram the system. When you have finished filling your tires with air, deflating them (in case of high psi), or changing a tire on your vehicle, you should always reset the tire pressure system.
How To Reset The Tire Sensors On Gm Cars.
Turn on the ignition, with the engine off. Push the trip odometer reset stem until tire pressure is displayed. The tire monitor service light will come on instantly if the tire pressure is below 25 psi.
I Have Searched And Not Been Able To Find Anything On Resetting The Tpms Sensors After Rotating The Tires On My 2011 Silverado.
Starting with lf tire, increase/decrease tire pressure until horn sounds. At the point, when 2011 chevrolet silverado 1500 low tire pressure warning light is on, be sure to check all tires for low air pressure and inflate as needed. Turn the ignition key to the “on” position without starting the engine
The Owners Manual Only Mentions Using A Tool To Do The Reset, Which I Don't Have.
Press and hold unlock and lock buttons on the keyless entry transmitter until horn sounds, and then lf turn signal will become illuminated. Place your relearn tool against the sidewall closest to the valve stem (where you fill and test your psi). 2011 chevrolet silverado 1500 ought to be equipped with tire pressure monitoring system (tpms) that utilizes tire pressure sensors to caution the driver when tire pressure is low.
Post a Comment for "How To Reset Tire Pressure Sensor Chevy Silverado 2011"