Skip to content Skip to sidebar Skip to footer
Home / 1996 / cherokee / crankshaft / grand / jeep / location / position / sensor

1996 Jeep Grand Cherokee Crankshaft Position Sensor Location

Post a Comment

1996 Jeep Grand Cherokee Crankshaft Position Sensor Location. 1996 jeep grand cherokee ltd. It starts and then stalls as i am driveing, i used my scan tool obd2.

Can you tell me where the Crankshaft Position Sensor is
Can you tell me where the Crankshaft Position Sensor is from www.justanswer.com

Random intermittent stalling and/or bucking while driving, stalling at stop signs, restarts immediatley sometimes (or not). 1996 jeep grand cherokee laredo 6 cyl 4.0l. Stalling and/or bucking may occur at 70 mph or 35 mph.

See Pic Of Sensor Below


Power to the coil is a dark green/black wire and will only be powered when the engine has a good rpm signal from the crank position sensor (ckp). Ive been looking for it but cannot find it. You must access it from under the car, it is a bear to reach on the ground.

I Got The Jeep Towed Home And The First Thing I Did Was Unplug The Cks (Crankshaft Position Sensor) And Put My Voltmeter Across The B And C Terminals And It Had Infinite.


Easy to use parts catalog. Where is the camshaft position sensor located on a 1996 jeep cherokee 4.0 the camshaft position sensor is inside the distributor, the crank sensor is at rear of engine in bell housing above starter. The crank position sensor is often the problem.

It Produces An On/Off Dc Voltage Signal That Can Be Easily Measured With A Multimeter, An Oscilloscope, And Even An Led Light.


All the parts your car will ever need. A sensor could be the reason why a 94 jeep grand cherokee laredo fails to start. My jeep died yesterday on the road.

After 20 Minutes It Starts Again.


Jeep ignition sensors part 2 crankshaft position sensor. The sensor is at about the 11 o'clock position on the bell housing. 1996 jeep cherokee 4.0l l6 crankshaft position sensor | rockauto.

This Sensor Uses A Reluctor To Gauge The Position Of The Crank.


At rear of engine above the starter motor goes into the bell housing. 1996 jeep grand cherokee laredo 6 cyl 4.0l. When the grand cherokee’s ecm determines that there is an issue with the signal coming from this sensor, it’ll throw the p0335 trouble code.

Post a Comment for "1996 Jeep Grand Cherokee Crankshaft Position Sensor Location"