Wabco Sensor Bu2 Location
Wabco Sensor Bu2 Location. Replace polewheel if not checked o.k. Install the new sensor spring clip in the bushing.
— connect roadside sensor at ye1. Sensors ye2 and bu2 must always be used on the lift axle to avoid Rht bu2 s2b m1 red red m2 yellow yellow m3 blue blue.
— Connect Roadside Sensor At Ye2.
If this assembly is mounted facing the rear, the ye sensor connections go to the roadside, and the bu sensor 4s/3m* — sensor locations vary by type of installation. N/a total number of stoplight power activations.
Wheel Disabled Asr, Rsc, Rsa:
If sensor extensions are used verify extension continuity and connections. Sensors ye2 and bu2 must always be used on the lift axle to avoid Ensure that each connection is secure.
Check Sensor Wiring, Replace Sensor If Necessary.
N/a total number of level one rss applications for all odr data. 9 internal modulator failure, inlet valve #2 verify proper installation. Visually inspect the tooth wheel and sensor to ensure no damage occurred during shipping.
Read And Observe All Caution And Warning Safety Alerts That Precede Instructions Or Procedures You Will Perform.
* if the lift axle is sensed in 4s/2m and 4s/3m installations: Or the rear of the trailer — determines sensor hookup. It alerts the driver of any faults or defects by means of a warning lamp and can deactivate the entire system or parts of it as required.
Make Sure The Spring Clip Tabs Are On The Inboard Side Of The Vehicle.
7 external abs modulator valve verify proper electrical installation. The recommended mounting location is midway between the side rails, close to the brake chambers the valve serves. The trailer — the ye sensor connections go to the curbside and the bu sensor connections go to the roadside.
Post a Comment for "Wabco Sensor Bu2 Location"